Reset Port - evertz MIO-CCE-4K/3G User Manual

MIO–CCE–4K/3G
SMPTE ST 2110/4K/3G/HD/SD Closed Caption Encoder with Media–to–IP Streaming
Example:
^AO PB –C1<cr>
This command will remove the active indication for Port B from field 1 captions.
^AO C1<cr>
This command will indicate that the current port is active in the captions in field 1. Activity for
other data types remain as previously set.
^AO C1 O<cr>
This command forces the current port to be active in field 1 captions. Activity for other data
types remain as previously set. If any other control port is active in CF1 will be reset.
5.6.5.

Reset Port

This command will reset a port. This command immediately clears the input and output data queues and
resets the MIO-CCE-4K/3G to the Transparent State in Field 1 and Field 2. Article and XDS output queues
are not reset by this command. They must be explicitly reset by using the queue articles and queue XDS
commands. Since other control ports may be simultaneously sending data, this command only affects the
fields and data types that have not been appropriated by other control ports. To reset all communication
ports, see the Reset Encoder (^F^F) command in section 6.3.2.
Command: ^Ar<sp>pn<cr>
Example: ^Ar PB<cr> Resets Port B
Page - 70
Revision 1.0