Table of Contents
Advertisement
installation
PROPANE / ULPG CONVERSION INSTRUCTION
Propane/ULPG Conversion Instructions
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
This conversion kit shall be installed by a qualified ser-
vice agency in accordance with the manufacturer's in-
structions and all applicable codes and requirements of
the authority having jurisdiction. If these instructions is
not followed exactly, a fire, explosion or production of
carbon monoxide may result causing property damage,
personal injury or loss of life. The qualified service agen-
cy is responsible for the proper installation of this kit.
The installation is not proper and complete until the op-
eration of the converted appliance is checked as speci-
fied in the manufacturer's instructions supplied with the
kit.
Conversion Kit new part # includes:
1
911-191
Stepper Motor LP for 885 SIT
1
905-065
Burner Orifice 1.80 mm propane
1
910-037
Pilot Orifice #30
1
918-590
Decal - Conversion to LP
1
919-728
Label Propane-Orange
1
904-529
5/32" long Allen Key
1
920-329
Instruction Sheet
1
919-727
Label Universal LPG-Red
1
918-272
Label Conversion to ULPG
1
905-064
Burner Orifice #52 ULPG
Caution: The gas supply shall be shut off prior to disconnecting
the electrical power, before proceeding with the conversion.
Always let the appliance cool to room temperature before ser-
vicing.
1 Remove the outer panels and safety glass — see manual.
2. Remove inner firebox glass — see manual.
3. Remove inner panels — see manual.
4. Remove all media installed on burner (glass, logs or stones, etc).
5. Lift off the far right base panel and loosen 2 screws on IFC cover-
-removed cover to access IFC.
920-329
| City Series ACV60E
60
ACB60E/ACV60E using SIT 885 NOVA Gas Valve
IF IN DOUBT DO NOT DO THIS CONVERSION!
WARNING
Base Panel
IFC Cover
ACB60E shown
ACB60E/ACV60E CITY SERIES
6. Disconnect the Cable coming from the Pressure Regulator Motor.
7. Remove and discard 2 Pressure regulator screws (A)using a (T20
or slot screwdriver,) Pressure Regulator (B) and Spring and Dia-
phragm (C) (see below).
8. Ensure the rubber gasket, which is prefitted as part of the Assem-
bly, is properly positioned. Install the new Pressure Regulator using
the 2x M4 x .7 screws supplied. Tighten the screws to 25lb-in. In
the event that the screw threads are cross threaded or stripped,
replace the valve assembly.
Install the enclosed propane or universal LPG identification label to the
valve body where it can be easily seen.
Pressure
regulator
screws
9. Re-attach the Pressure Regulator wire (disconnected in Step 6),
tooltip
and re-situate the IFC, secure the screws that fasten the IFC Mount-
ing Brackets.
10. Remove pilot hood by lifting up and off.
Pilot Hood
11. Remove the trim cover on right side of burner by lifting off. Also remove
the burner surround by sliding to the left and lifting off.
Trim Cover
1
Cable from motor
Burner Surround
02.17.21
Advertisement
Table of Contents
