System Commands; Restarting The Matrix; Querying The Cpu Time - Lightware MX-FR9 User Manual

   
7. Programmer's Reference
Example
ȩ {elist=?}
Ȩ (ELIST#1 Notice BOOT p:2 o:1)CrLf
Ȩ (ELIST#2 Notice SERIAL p:0 o:1 )CrLf
Ȩ (ELIST#3 Notice CARDINIT p:81 o:1 ) CrLf
Ȩ (ELIST#4 Notice CARDINIT p:2 o:1 )CrLf
Ȩ (ELIST#5 Notice READY p:0 o:1)CrLf
There are no errors, only standard notices that occur upon boot up.

INFO: The error list can contain NOTICEs and WARNINGs under normal operation. These entries do not
mean that there is any problem with the matrix!
MX-FR Series Modular Matrix Frames – User's Manual
7.7. System Commands
7.7.1. Restarting the Matrix
The matrix router can be restarted without unplugging power.
Command and Respons
ȩ {RST}
Ȩ (Booting...)CrLf
Ȩ (<name>•Ready!)CrLf
Parameters
The matrix reboots and sends a message when it is ready.
Example
ȩ {rst}
Ȩ (Booting...)CrLf
Ȩ (MX-FR17 Ready!)CrLf

INFO:
7.7.2. Querying the CPU Time
The matrix router has a built-in real time clock on the MX-CPU2 processor board. This command allows
reading the CPU time.
Command and Response
ȩ {GETTIME}
Ȩ (<date>•<time>•UTC+<zone>)CrLf
Parameters
See the next section.
Example
ȩ {gettime}
Ȩ (04.10.2016. 16:52:34 UTC+0100)CrLf
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
#reset #restart
The response can be seen only if the connection to the router is still alive.
#date #time
112
<name> is the type of the matrix.