Applied Ports (Network Settings); Factory Default Settings - Lightware MX-FR9 User Manual

   
11. Appendix
Ethernet Port
Connector type ............................................................................. Neutrik etherCON / RJ45 female connector
Ethernet data rate .......................................................................... 10/100Base-T, full duplex with autodetect
Power over Ethernet (PoE) .......................................................................................................... Not supported
Ethernet protocol ..................................................................................................... TCP/IP, HTTP, TFTP, Telnet
Alarm Output
Connector type ......................................................................................................SMPTE 269M standard BNC
11.2. Applied Ports (Network Settings)
The following ports are necessary to pass via a network switch/firewall for a proper working between the
device and the softwares:
Purpose/function
Device Discovery
Remote IP
LW2 protocol
HTTP port
Affected
Protocol Port nr.
software
LDC UDP 224.0.0.251:5353
LDC UDP 230.76.87.82:37421
- TCP 10001
- TCP 80
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
MX-FR Series Modular Matrix Frames – User's Manual
11.3. Factory Default Settings
IP address
Subnet mask
Static gateway
DHCP
LW2 Port number
HTTP Port number
Control protocol
Crosspoint state
Input/Output ports
Emulated EDID (input ports)
EDID memory
Crosspoint presets
Preset names
Port names
Baud rate
Databits
Parity
Stopbits
Control protocol
Network Settings
192.168.254.254
255.255.0.0
0.0.0.0
Disabled
10001
80
LW2
Video Port Settings
I1 input port on all output ports
Unmuted, Unlocked
F49 – Universal HDMI EDID
Empty (User and Dynamic EDIDs)
All outputs to I1
Preset1, Preset2,...
Input1, Input2...; Output1, Output2...
RS-232 Settings
57600
8
No
1
LW2
173