Mx-Fr17 - Lightware MX-FR9 User Manual

   
3. Product Overview
3.10. MX-FR17
Front View
7
5
6
8
1 USB control USB connection for Lightware
Device Controller software.
2 Menu Displays status information
display and menu operation.
Menu Arrows, escape, and enter
3
navigation buttons for menu navigation.
4 Status LEDs CPU live LED blinks to indicate
normal operation. Power LED
shines green when the router
is powered on.
5 Control lock Press long to disable or enable
front panel buttons. When it
shines red, all operations on
the front panel are prohibited.
6 Output lock Locks one (or more) outputs.
Inhibits accidental
changing on the protected
output.
7 Source Select an input or preset or to
buttons view the selected input's state.
1 2 3 4
8 Destination Destination buttons can be
buttons used to select an output, or
view the selected output's
state.
9 Take / Auto Displays the current switching
mode (TAKE or AUTOTAKE).
Long press toggles
switching mode, short press
executes switching in TAKE
mode.
Preset Load preset: apply a previously
q
buttons saved crosspoint preset from
one of the preset memories.
Save preset: stores current
crosspoint state in one of the
preset memories.
EDID mode Switches the Menu display
w
input
to EDID menu allowing EDID
switch, EDID save etc.
Signal Displays live sources and
e
present attached sinks on source and
destination buttons.
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
MX-FR Series Modular Matrix Frames – User's Manual
Rear View
9
q
q
e
w
w
e
1 Status LEDs
2 DIP settings Special settings can be made
Alarm out
3
the
Preview
4
output
Test input
5
6 Serial port
1 23 4 5 6
LED indicators for internal DC 7 Ethernet
power voltages and alarm. port
with these switches.
Standard SMPTE 269M alarm
output with BNC connector.
See the Alarm Output section
8 Reset
for more information.
button
DVI output connector that is
directly connected to the 17th
output. See the DVI Inputs and
Outputs and the Test Input
9 CPU live
and Preview Output sections
for more information.
Output
q
DVI input connector, which can
boards
be configured as an alternative
for the 17th input. See the DVI
Inputs and Outputs and the Input boards Modular input board slots.
w
Test Input and Preview Output
sections.
9 pole D-SUB female connector e Power
for RS-232 serial connection.
See the RS-232 Ports section
for more information.
27
7 8
9
Locking RJ45 connector.
Remote control port for
connecting the unit to Local
Area Network (LAN) and for
firmware update. See the
Ethernet Ports section for
more information.
Reset button; reboots the
matrix. It has the same result
as disconnecting the device
from the power source and
reconnecting it again.
CPU live LED blinks to indicate
normal operation.
Modular output board slots.
Connect sink devices to these
connectors.
Connect source devices to
these connectors.
Mains switch and AC power
connector.