Umx Input Port - Lightware MX-FR9 User Manual

   
7. Programmer's Reference
Query or set the color of the test pattern (which is activated when there is no incoming signal).
Supported Boards
▪ MX-DVII-HDCP-IB; MXD-UMX-IB
Querying the Parameters
Command and Response
ȩ {:SETBG#<in>@<S/C/A>I=?}
Ȩ (SETBG#<in>@<S/C/A>I=<rgb_color>;)CrLf
Example
ȩ {:SETBG#9@SI=?}
Ȩ (SETBG#9@SI=255;0;0;)CrLf
The color of the test pattern is red, see the legend for the details.
Setting the Parameters
Command and Response
ȩ {:SETBG#<in>@<S/C/A>I=<rgb_color>;}
Ȩ (SETBG#<in>@<S/C/A>I=<rgb_color>;)CrLf
Example
ȩ {:SETBG#9@SI=255;255;0;}
Ȩ (SETBG#9@SI=255;255;0;)CrLf
The color of the test pattern has been changed to yellow.
Parameters
The RGB color of the test pattern can be set by these parameters:
<rgb_color> = Red;Green;Blue
MX-FR Series Modular Matrix Frames – User's Manual
Timing Parameters
The system continuously measures the parameters of the signals. The answer consists of 12 parameters
that could be useful for advanced debugging processes.
Supported Boards
▪
Querying the Parameters
Command and Response
ȩ {:GETTIMINGS#<in>@<S/C/A>I=?}(SETBG#<in>@<S/C/A>I=<rgb_color>;)CrLf
Ȩ (GETTIMINGS#<in>@<S/C/A>I=<Timing_codes>;)CrLf
Example
ȩ {:GETTIMINGS#9@SI=?}
Ȩ (GETTIMINGS#9@SI=2200;1920;89;44;147;1125;1080;4;5;36;148484;24;)CrLf
For more information about the measured values, please contact Lightware Support.
7.10.7. UMX Input Port
7.10.7.1. Port Parameters and Settings
The port parameters and settings are the same as in the case of DVI-I input port, see the
section.
7.10.7.2. Audio Source Selection
Query or set the audio signal routing.
Supported Boards
▪
Querying the Parameters
Command and Response
ȩ {:AUDSRC#<in>@<S/C/A>I=?}
Ȩ (AUDSRC#9@SI=<aud_mode>;)CrLf
Example
ȩ {:AUDSRC#9@SI=?}
Ȩ (AUDSRC#9@SI=C;)CrLf
The actual setting is in the response; see the legend for the details.
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
MX-DVII-HDCP-IB; MXD-UMX-IB
MXD-UMX-IB
136
DVI-I Input Port