Error Codes Of The Dryexxeco Control® Advanced-Eth - Ecolab DryExxEco Advanced-ETH Operating Instructions Manual

Troubleshooting
Error codes of the DryExxEco control® Advanced-ETH
12.3
Error codes of the DryExxEco control
The error codes are displayed in plain text on the screen of the control
DryExxEco
Fault description
Screen output:
SI automated circuit
breaker, dig. outputs
triggered!
Screen output:
Error: SI automated circuit
breaker, cooler has
triggered!
Screen output:
Fault: Belt lubricant empty
Screen output:
Fault: Communication with
partner (enable)
The following fault can occur in all circuits (1-16), but is only described here
once as an example.
This error message can only be displayed, if in
[General parameters] - [operating mode]" on page 74 the monitoring of the
dosing quantity is switched on (button [ON] green)!
Fault description
Screen output:
Fault: Dosing quantity circuit 1 =>
check plant => ECOLAB
Rev. 02-09.2017
®
Advanced-ETH.
Cause
Excess current
Short circuit
Excess current
Short circuit
Belt lubricant
supply empty
Ethernet
communication is
interrupted.
Cause
Overdosing, e.g. due to line
break or missing spray
nozzle.
Underdosing blocked line
system or nozzle.
Pump is conveying with the
incorrect values
86
® Advanced-ETH
Remedy
Localise and rectify the cause of the excess
current. Switch the fuse in the switch cabinet
back on.
Localise and rectify the cause of the short
circuit. Switch the fuse in the switch cabinet
back on.
Localise and rectify the cause of the excess
current. Switch the fuse in the switch cabinet
back on.
Localise and rectify the cause of the short
circuit. Switch the fuse in the switch cabinet
back on.
Provide new belt lubricant (
8.3.2 „Failure of the belt lubricant - empty
message" on page 47).
Localise and rectify communication break.
Ä Chapter 10.8.2 „Overview:
Remedy
Localise and replace
line break or missing
spray nozzle.
Clean, or replace,
blocked line system or
nozzle.
Check the pump.
Ä Chapter