System Settings" [Setup] [Exchange Of Signals]; System Settings" [Time] - Ecolab DryExxEco Advanced-ETH Operating Instructions Manual

Layout of the software display
System settings > System settings Time
10.4.6.2 „System settings" [Setup] [Exchange of signals]
In [Exchange of signals] implements the parameter setting for the Ethernet interface. IP,
subnet mask and router IP.
Fig. 25: „System settings" [Setup] [Exchange of signals]
1. button [Setup] Press to access the [Setup] .
ð The overview: „Setup: Selection" is displayed.
2. Press button [Setup signal exchange] .
ð The overview: „Setup communication" is displayed.
3. Setting the IP address, subnet mask and the router ID.
ð Separate settings are entered here.
4. Press button [Set IP address] .
ð The data from the field to the right of the button [Set IP address] are set.
5. Press button [Get IP address] .
ð The data from the settings are exported from the control.
10.4.7

„System settings" [Time]

The time and date for the control and the PLC are set on this level.
Fig. 26: „System settings" [Time]
1. Press button [Time] to access the settings.
ð The overview: „Date" , „Time" for the control and the PLC are displayed.
2. Press the field „Date" .
ð The „Date" can be set.
3. Press the field „Time" .
ð The „Time" can be set.
4. Press button [Time in PLC] .
ð The values are transferred into the PLC and displayed in the field underneath the
button.
Rev. 02-09.2017 64