General Parameters] - Ecolab DryExxEco Advanced-ETH Operating Instructions Manual

1. In the „home screen"
use the
ð The overview: „Parameters: General" is displayed.
Ä Chapter 10.8.1 „[General parameters]" on page 73
2. Press button [operating mode] .
ð The overview: „Operating modes" is displayed.
Ä Chapter 10.8.2 „Overview: [General parameters] -
[operating mode]" on page 74
3. Press button [Monitor Consumption] .
ð Monitoring the dosing quantity of all dosing circuits is displayed.
Ä Chapter 10.8.2.1 „[General parameters] - [operating mode] -
[Monitoring consumption]" on page 75
4. Press button [Unit Meter] .
ð The setting level of the units (bottles or crates) per pulse is displayed.
Ä Chapter 10.8.3 „[General parameters] - [Unit Meter]" on page 76
10.8.1

[General parameters]

Setting the control times for the pump, suction lance and the optional OGM
(oval gear meter).
Fig. 40: Overview: [General parameters]
1 The line pressure in the dosing line is conveyed back
into the feeder containers for a defined time.
2 The line pressure is built up in the dosing line in a
defined time.
3 Delay time of the incoming empty signal of the suction
lance.
4 Pulse values exported from an OGM.
Press button [General parameters] to access the settings.
ð The overview: „Parameters: General" is displayed.
Ä Chapter 10.3 „ „home screen" (start screen)" on page 54
button to switch to the general parameters.
Only when in this view the button [Monitor Dosing quantity] on [ON]
(green) is switched on, the additional button appears
[Monitor Consumption]!
73
Layout of the software display
Overview: General parameters > General parameters
Rev. 02-09.2017