Dryexx Wall Mounting - Ecolab DryExxEco Advanced-ETH Operating Instructions Manual

Assembly
DryExx wall mounting®
6.2

DryExx wall mounting

The applicator station DryExx
mounting is the intended installation mode, or alternatively onto a standard console. The
components should ideally be set up in the area of the filling plant. In this process, it
should be noted that the units are easily accessible and the max. permissible ambient
conditions are observed. In the event of installation on a stand console, ensure that this is
securely anchored to the floor.
The dimensions of the DryExx
Ä Chapter 14.4.1 „DryExxEco
The following points should be noted during assembly:
– Make sure there is adequate access for maintenance to be carried out!
– The location must be as dry and frost-protected as possible.
– Install the applicator station as close as possible to where the lubricant is
stored (canister, barrel, container, tank) to ensure that the suction tubing is
as short as possible.
– The DryExx
The procedure should be selected as follows:
1. Choose a suitable mounting location (wall, etc.).
2. Ensure that all required supply lines (power, water, signal cable to the control unit,
dosing medium) are present.
3. Measure the mounting points and transfer to the mounting site.
4. Make the holes.
5.
®
DryExx
6. Check the alignment, adjust if necessary.
7. Carry out connection work.
Rev. 02-09.2017
®
®
is shipped from the factory ready for connection. Wall
® must be installed horizontally and securely.
should be mounted using the fastening elements provided.
®
are given here:
® " on page 91
36