General Parameters] - [Operating Mode] - [Monitoring Consumption] - Ecolab DryExxEco Advanced-ETH Operating Instructions Manual

10.8.2.1 [General parameters] - [operating mode] - [Monitoring consumption]

The monitoring of the dosing quantity of all dosing circuits is carried out here.
Fig. 42: Overview: [General parameters] - [operating mode] - [Monitoring consumption]
1 Valve number
2 Value of the actual dosing.
3 The button [=>] can be used to transfer the value to
„Set" .
Pressing the
screens. These buttons can be used display the
1. In the „home screen"
use the
ð The overview: „Parameters: General" is displayed.
Ä Chapter 10.8.1 „[General parameters]" on page 73
2. Press button [operating mode] .
ð The overview: „Operating modes" is displayed.
Ä Chapter 10.8.2 „Overview: [General parameters] -
[operating mode]" on page 74
3. Press button [Monitor Consumption] .
ð Monitoring the dosing quantity of all dosing circuits is displayed.
4.
Press the
ð The next screen with the corresponding valves is displayed.
5. Press the
ð The previous screen with the corresponding valves is displayed.
Overview: General parameters > Overview: General parameters - operating mode
button displays a second button on the subsequent
(previous) screen with the corresponding valves.
Ä Chapter 10.3 „ „home screen" (start screen)" on page 54
button to switch to the general parameters.
button.
button.
75
Layout of the software display
4 Display of the „Set" value.
5 +/- tolerance of the set value in %.
6 +/- tolerance value conversion into absolute values
(ml).
(next) or the
Rev. 02-09.2017