Home Screen" (Start Screen); System Settings - Ecolab DryExxEco Advanced-ETH Operating Instructions Manual

Layout of the software display

System settings

10.3

„home screen" (start screen)

After connecting the power supply by switching on the main switch on the control cabinet
(see Ä Chapter 9 „DryExxEco control
will be the „home screen" . From this „home screen" you can call up all the settings on the
control.
The home screen displays the following:
Fig. 13: Start screen
1 Status display / message: „No fault within the control" .
2
The manufacturer logo
button to switch over to the „System settings" .
Ä Chapter 10.4 „ „System settings" " on page 54
3 Type of software control: „DryExx Eco Advanced-ETH"
4
OFF" .
Ä Chapter 10.5 „[Statistics]" on page 65
5
Ä Chapter 10.6 „Overview: [Archive]" on page 65
6
Parameters" .
10.4 „System settings"
Access to the „System settings" on the control is not immediately visible and is
hidden behind the manufacturer logo. Pressing the manufacturer logo
[ECOLAB] calls up the „System settings" .
Fig. 14: System settings
1
switches back over to the „home screen" .
Rev. 02-09.2017
Button to switch over to „Statistics ON/
Button to switch over to the Archive
Button to switch over to „Circuit
® Advanced-ETH" on page 49, Pos. 2), the display
Ä Chapter 10.7 „Overview:
[Circuit Parameters]" on page 69
acts as a
7
Ä Chapter 10.9 „[Messages]" on page 76
8
Ä Chapter 10.10 „Control: Logout" on page 77
9
Parameters" .
Ä Chapter 10.8 „Overview:
[General parameters]" on page 72
10 Display of the valves integrated into the system.
11
Ä Chapter 10.11 „LED Test" on page 77
12 Current set date date and time
Ä Chapter 10.3 „ „home screen" (start
screen)" on page 54
54
Button to switch over to „Messages" .
Button to „logout" from the system.
Button to switch over to „General
Button to run the „LED test" .