Boot The Call/Door Box, Enable Its Web Interface - Omron LD-60 User Manual

5.3 Call/Door Box Configuration

Boot the call/door box, Enable its web interface

NOTE: Simply applying 12 VDC power to the call/door box will boot the box,
but extra steps are required to enable the built-in web interface, which gives you
access to the configuration of the call/door box.
1. Enable the call/door box web interface.
This can be done in either of two different ways.
Using the DIP switch:
a. Remove power from the box.
b. Move Position 2 (DP2) on the DIP switch to ON.
When power is applied, this will reset the LAN and WLAN settings and also
provide a means to access the built-in web interface.
c. Apply power to the box.
NOTE: After changing and storing the settings in the web interface, you
will need to switch the DIP switch position 2 back to OFF and then
power-cycle the call/door box.
Using the push-button:
a. Remove power from the box.
b. Re-apply power to the box.
All the LEDs will come on. The red LED will be on, but not blinking.
c. Wait 60 seconds.
d. Press and hold the button.
If the lights go out before you press the button, you will need to recycle power, to
start the process over.
While pressing the button, all of the lights will go out, indicating that the box
itself has booted, but not the web interface.
e. Continue to hold the button down until all of the lights flash briefly one time,
and them come back on.
This confirms that the box is enabling the web interface.
f. Continue to hold the button down for about 10 more seconds, until all of the
lights go out.
You can then release the button and connect to the web interface.
60
NOTE: If you release the button before that time, the box will have
booted, but the web interface will not be enabled.
LD Platform Peripherals Guide 13732-000 Rev J