Omron LD-60 User Manual page 141

Figure 9-13 Installation Location of HAPS Sensors on the Underside of the LD-250
Cable the sensors as follows:
1. Use a 4 mm hex key and the two supplied M5 socket head cap screws and washers to
install the sensor marked Front at location [(A) in Figure 9-13].
2. Route the cable as shown in Figure 9-14, over the bracket and up the side of the chassis,
adjacent to the caster mount.
Use a zip tie to secure the cable to the available cable tie mounts positioned on the
chassis, leaving no slack.
3. Feed the cable behind the speaker mount as shown in Figure 9-15. Use a zip tie to
secure the cable to the available cable tie mounts positioned on the chassis, leaving no
slack.
13732-000 Rev J
Figure 9-14 LD-250 Front HAPS Cable Routing Over the Sensor Bracket
LD Platform Peripherals Guide
Chapter 9: High Accuracy Positioning System
141