Omron LD-60 User Manual page 134

9.3 Sensor Installation on the LD-60, LD-90, and LD-xxxCT
2. Attach the bracket to the underside of the AMR, with the cable between the bracket and
the platform. The sensor will already be attached to the bracket.
Use the M5 screws and washers previously removed. Use Loctite 243.
3. Route the sensor wires back to behind the right drive wheel, as shown.
4. Install two cable-tie anchors to the underside of the platform, along the path of the
134
Figure 9-3 Screws to Remove, Circled
Figure 9-4 Front Cable Route, Shown in Yellow
LD Platform Peripherals Guide 13732-000 Rev J