Basic Operation; Plugging In And Powering Up - Novexx Solutions U-RX Operating Instructions Manual

06/15 Rev. 03

Basic operation

Plugging in and powering up

 Make sure that the unit is switched off before connecting the power cable.
 Only operate the unit with mains voltage set in the fuse insert[1].
 Ensure that the unit is set to the mains voltage supplied by your electricity
 Only connect the unit to a grounded power socket fitted to authorised
 The power cable should not be more than 3 meters long.
 Make sure, that the power supply socket for the device is readily
 In case of emergency, switch off the device and disconnect the power
1. Ensure that the mains voltage set for the
unit is the same voltage as the local
electricity supply. To do this, look for the
number in the small window next to the
power switch [1]. This number indicates
the required voltage.

If the voltage set is not the same as the
local voltage, please call a qualified
technician to change the setting.
For further information, refer to the service

manual.
2. Ensure that power switch [2B] on the U-RX
is set to "0" (off).
3. Using the power cord [2A] supplied, plug
the U-RX into a socket connected to the
local electricity supply.
4. Turn on the unit (switch set to "I").
OPERATING INSTRUCTIONS
WARNING!
The unit operates using mains voltage! Touching electrically live parts may
expose you to hazardous electrical currents and may lead to burns.
provider.
standards.
The device can only be disconnected completely by pulling off the power
supply cable. For this reason:
accessible!
supply cable!
U-RX
[1] Check the mains voltage set for the U-RX on the power
socket of the unit (shown here as 230 V).
A
[2] U-RX power supply
Setting up, operation
B
9