U-Rx As Rewinder - Novexx Solutions U-RX Operating Instructions Manual

06/15 Rev. 03

U-RX as rewinder

•
U-RX is turned on and ready for operation
(red start/stop button is lit).
•
Operational mode and winding direction
are already set for the unit.
How to? – See section

on page 11.

The material end is attached in a diffe-
rent way on U-RX with 1.5" or 3"/4" winding
mandrel respectively with/without card-
board core.
1. Remove the outer guide disk [1A]. To do
this, open the locking lever [1B].
2. Preparing the rewinding mandrel:
(1.5" with/without core)
Pull out lock clamp [2A] from the rewinding
mandrel.
(3"/4" without core)
Push in the lock wedge [3A] to the limit.
(3"/4" with core)
Pull out the lock wedge [3A] up to the limit.
OPERATING INSTRUCTIONS
U-RX
Rewinding settings
B
[1] Remove the outer guide disk (A).
[2] The U-RX's 1.5" rewinding mandrel
A Lock clamp
[3] The U-RX's 3"/4" rewinding mandrel
A Lock wedge
16
Setting up, operation
A
A
A