Assembling A Rewinding Mandrel With A Different Diameter - Novexx Solutions U-RX Operating Instructions Manual

06/15 Rev. 03
Assembling a rewinding
mandrel with a different
diameter
Tools
2 mm Allen screwdriver
Dismantling
1. Pull out the lock clamp [7C].
2. Loosen the set screw [7B], unscrew [8A]
completely.
3. Push out parallel pin [7A] laterally.
4. Pull the rewinder mandrel off the axle [9].
Assembly
Assemble the rewinder mandrel in reverse
order to dismantling it. Doing so, ensure
that:

The set screw [8A] catches in the
groove [9A] of the axle.
OPERATING INSTRUCTIONS
U-RX
[7] Outer rewinding mandrel fastener
[8] Inner rewinding mandrel fastener
A
[9] Pulling out the rewinder mandrel
Setting up, operation
A
B
C
A
13