Setting Up The Print-Stop Function - Novexx Solutions U-RX Operating Instructions Manual

06/15 Rev. 03
Setting up the print-stop
function
CAUTION!
Paper jam between printer and
U-RX can cause dangerous si-
tuations.
 Always apply the print-stop
function.
The print-stop function prevents paper
jams between the printer and the U-RX in
case the rewinder stops. If this happens,
printing stops.

The printer must be equipped with an
USI signal interface (regardless, if 5 V or
24 V version).
1. Turn off the printer and the U-RX.
2. Connect the printer to the U-RX with the
A7264 cable.
3. Turn both units back on.
4. Set the following parameter for the printer:
DP INTERFACE > Start print mode
"
active
OPERATING INSTRUCTIONS
U-RX
= "
Level low
10
Setting up, operation