Novexx Solutions U-RX Operating Instructions Manual page 17

06/15 Rev. 03
3. Attaching the material end to the rewinding
mandrel:
(1.5" without core)
Slide the lock clamp over the end of the
material [4].
(1,5" with core)
Push the cardboard core onto the rewin-
ding mandrel [6]. Slide the lock clamp un-
der the cardboard core. Fasten the end of
the material to the cardboard core (adhe-
sive tape).
(3"/4" without core)
Push the material end into the groove in the
rewinding mandrel [5] and fix it by a turn of
the mandrel.
(3"/4" with core)
Push the cardboard core [6A] onto the
rewinding mandrel. Push the wedge [6B]
in. Fasten the end of the material to the
cardboard core (adhesive tape).

Thread the material according to the
winding diagram.
4. Hang the outer guide disk [7A] onto the
rewinding mandrel and push it to the edge
of the material web respectively the
cardboard core. Close the locking lever
[7B].
5. Press the start/stop button.
The U-RX will now rewind the material until
the dancer arm comes to the middle
position. The start/stop button light flashes
during the rewinding process. When the
desired position is reached, the light is
turned off.

During this time, the printer may not
send any material to the U-RX.

If the red light does not turn off, there
has been an error. In this case, repeat
step 3.
OPERATING INSTRUCTIONS
U-RX
[4] (1,5") Securing the end of the material under the lock clamp.
[5] (3"/4") Feed the material end into the groove in the rewin-
ding mandrel.
A
[6] (3"/4") Fixing the cardboard core (A) with the wedge (B).
[7] (3"/4") Outer guide disk (A) at the U-RX.
Setting up, operation
B
A
B
17