Safe Operation - Novexx Solutions ALX 73 Series Service Manual

04/13 Rev. 5.07-00

tions.

completed.
Protection measures in applicator mode
a) Movable, separating guards according to EN 953
After all servicing or repair work

Safe operation

Protect against injuries that can result from electrical current
Power connection:
SERVICE-HANDBUCH
Carry out test runs using the task-specific settings under near production condi-
Only put the machine into operation after at least one successful test run has been
WARNING!
Danger of crushing between dispenser edge and applicator pressure plate due to
applicator movement !
 Prevent personnel from reaching between dispensing edge and applicator by
installing higher-level protective guards
WARNING!
Risk of an accident due to moving or loose parts!
 Re-install all covers and safety equipment.
 Check for firm seating of all screw connections that were loosened during the
work.
 Remove all tools and other aids used during service and repair from the working
area of the labeller.
Verify flawless functioning of all safety equipment.

WARNING!
This unit operates at mains voltage! Coming into contact with electrically live com-
ponents can cause potentially lethal electrical shocks and burns.
 After assembling, check the printer according to the regulations relevant in your
country.
WARNING!
Contact with energised components can result in life-endangering currents through
the body as well as burns. The label dispenser is connected with the mains supply!
 Only allow work on the electronics system to be done by authorised electronics
technicians.
 Observe the following information unconditionally.
The machine side power connector has a definite phase position.
 Pay attention to the phase position when connecting the machine.
Power switch = separator.
 If the power switch is not accessible due to the installation position of the machine,
a suitable separator has to be provided by the system integrator.
ALX 73x
a
.
9