Novexx Solutions U-RX Operating Instructions Manual page 19

06/15 Rev. 03
4. Hang the outer guide disk [12A] onto the
rewinding mandrel and push it to the edge
of the material roll. Close the locking lever
[12B].
5. Press the start/stop button.
The U-RX will now unwind the material until
the dancer arm comes to the resting
position (left stop). The start/stop button
light flashes during the unwinding process.
When the desired position is reached, the
light is turned off.

During this time, the U-RX may not
send out any material.

If the red light does not turn off, there
has been an error. In this case, repeat
step 3.
OPERATING INSTRUCTIONS
U-RX
[12] (3"/4") Outer guide disk (A).
Setting up, operation
B
19
A