ABB ACS2000 User Manual page 87

c d p c o n T r o l pa n e l
—
101
Control panel overview
1 L ->
StateINU
MOTOR SP
POWER
Fault memory
The fault memory includes information on the 64
most recent fault events that occurred in the drive.
The name of the fault and the actual time are
displayed. The procedure for selecting and
clearing the fault history is described in
section Displaying and resetting an active fault.
When a fault or warning is generated in the drive,
the message will be displayed immediately, except
when in drive selection mode.
Changing from the fault display mode to other
display modes is possible without resetting the
fault first. When no keys are pressed, the fault or
warning text is displayed as long as the fault is
pending.
Selecting the actual signal display
The actual signal display mode is selected by
pressing the ACT key.
Status line
600.0 rpm
ReadyOn
Actual signal
0.00 rpm
names and
0.0 kW
values
Selects the
function mode
Enters the
selection mode
Acknowledges
the selection
Scrolls through
signal/fault
message
Selects actual
signal/fault
1 L -> 600.0 rpm
StateINU ReadyOn
MOTOR SP 0.00 rpm
POWER 0.0 kW
Toggle between actual signal display and fault
history
When in actual signal display mode, the fast up/
down keys allow the user to toggle between actual
signal display and fault history display.
1 L ->
1 LAST FAULT
+Overspeed
070730 12:30:02.3256
Displaying three actual signals
1. To display the full name of three actual signals,
press and hold the ACT key.
1 L ->
StateINU
MOTOR SPEED
POWER
2. To return to the actual signal display, release the
ACT key.
Selecting actual signals
1. To select the actual signal display, press the ACT
key.
1 L ->
StateINU
MOTOR SP
POWER
2. To select a row where the actual signal is to be
displayed, press the corresponding slow
navigation key. A blinking cursor indicates
the selected row.
1 L ->
StateINU
MOTOR SP
POWER
87
600.0 rpm
600.0 rpm
600.0 rpm
ReadyRun
600.00 rpm
75.0 kW
600.0 rpm
ReadyRun
600.00 rpm
75.0 kW