ABB ACS2000 User Manual page 6

6 A C S 2 0 0 0 , 4 K V U S E R M A N U A L
Target groups and required qualifications
The equipment presented in this manual is part of
an industrial environment where voltages are
present that contain a potential hazard of electric
shock, burn, physical injury and/or death. For this
reason, only personnel who have a thorough
knowledge of the equipment and the industrial
environment and have obtained the required
qualification should handle, install, operate or
maintain the equipment.
The manual addresses personnel who are
responsible for unpacking, transportation,
installation, operation and maintenance of the
equipment. The personnel must carry out the
below listed tasks in a manner that does not
cause physical harm or danger and ensures
the safe and reliable function of the equipment.
Note: Commissioning of drive equipment must
only be performed by qualified and certified ABB
personnel.
Handling
Personnel must be skilled and experienced in
unpacking and transporting heavy equipment.
—
Table 2: Relevant chapters of the manual
Chapter
General information
Safety
Power electronics and cabinet features, Overview
Transportation
Mechanical installation
Electrical installation
Operation
Troubleshooting and maintenance
Mechanical installation
Personnel must be qualified to prepare the
installation site according to the site and
equipment requirements and to perform
the installation accordingly.
Electrical installation
Personnel must have a sound knowledge of the
relevant electrical codes and specifications
covering low and medium voltage equipment,
be experienced with electrical wiring principles
and understand the electrical symbols typically
used in wiring diagrams.
Operation
Personnel include all persons who operate
the equipment as required for the specified
application. Personnel must know the driven
process and be adequately trained to operate
the equipment. Special knowledge of frequency
converter technology is not required.
Maintenance
Personnel must be thoroughly familiar with the
construction of the equipment, be adequately
trained to check the equipment and to perform
the scheduled service and maintenance tasks.
Personnel must know the safe shutdown and
grounding procedures for the equipment.
Handling Installation
x x
x x
x
x
x
Operation Maintenance
x x
x x
x x
x
x
x