ABB ACS2000 User Manual page 109

T r o U b l e S h o oT i n G a n d m a i n T e n a n c e
7. Remove the screws on the left/right side of the
phase module.
• Screw type: M10 socket-head screw
• Required tool: 10 mm socket
8. Frame 1 - Insert the module tray into the cabinet
along the lower sides of the phase module.
• Slide the phase module tray tool in, until it makes
contact with the metal flange on both sides of
the NP frame
• Open the securing hinges of the tray tool to
firmly attach the tray tool to the drive frame (This
DANGER
prevents any movement of the tray tool while
pulling out the phase module.)
WARNING
CAUTION: Make sure to open the hinges to prevent
CAUTION
dropping the phase module and the tray tool.
NOTICE
Phase module screws
8. Frames 2, 3 - Insert the module tray into the
cabinet along the lower sides of the phase
module.
• Slide the phase module tray tool in, until it makes
contact with the metal flange on both sides of
the NP frame and the spring clip engages
9. Hold the phase module by the handle and pull it
out slowly until it is flush with the leading edge
of the tray.
Note: Verify that the module tray tool is
firmly in place during this step.
109