ABB ACS2000 User Manual page 67

e l e c T r i c a l i n S Ta l l aT i o n
—
—
85
Table 23: Control cable requirements
Terminal entry unit
—
Signal type
86
Cable entry
Analog in
Analog out
Digital in
Digital out
Pulse encoder
Cable entry
TEU (Terminal Entry Unit) for power cables and
ground cable
The TEU for the power cables and the ground cable
of the drive allows for either top or bottom cable
entry.
The unused cable entry is closed by a cover (6).
4
1 PE ground bus
2 Power IN terminals
3 Motor OUT terminals
4 Strain relief
5 Cable entry cover
—
85
General cable type Cross-section
Twisted pair(s) - Overall 0.5 to 2.5 mm² / 20
shield to 12 AWG
Twisted pair(s) - Overall 0.5 to 2.5 mm² / 20
shield to 12 AWG
Twisted pair(s) - Overall 0.5 to 2.5 mm² / 20
shield to 12 AWG
Twisted pair(s) - Overall 0.5 to 2.5 mm² / 20
shield to 12 AWG
Twisted pair cable with
separately shielded 0.5 mm² / 4 x (2+1) /
pairs and overall shield 20 to 18 AWG
5
2
3
1
5
Cable entry for ground cable, line supply and
motor cables
Cable entry for ground cable, line supply and motor
cables (1) is separate from the entry for auxiliary
power and control cables (2).
1
—
86
The entry plate for ground, line supply and motor
cables (1 in Figure 86) is a 6.4 mm [0.25 in] thick
aluminum plate. The entry holes need to be
punched on-site to properly accommodate
customer cables.
This aluminum plate is either attached to the top or
the bottom access hole - whichever is receiving the
cables.
The unused entry access hole is covered by a steel
plate.
Cable entry for auxiliary power and control cables
The cable entry access holes for the auxiliary power
and control cables (2 in Figure 86) are covered by an
aluminum plate.
This aluminum plate needs to be punched on-site
to properly accommodate the customer incoming
cables.
This aluminum plate is either attached to the top or
the bottom access hole - whichever is receiving the
cables.
The unused entry access hole is covered by a steel
plate.
67
2
Front of drive