ABB ACS2000 User Manual page 56

56 A C S 2 0 0 0 , 4 K V U S E R M A N U A L
—
63
Frame 2 Prepare
drive for storage
—
64
Frame 3 Prepare
drive for storage
2
1 Desiccant bag
2 Humidity sensor tab
—
63
2
1 Desiccant bag
2 Humidity sensor tab
—
64
5. Use polyethylene or equivalent for packaging
furnished:
• 0.3g/m²/24h water vapor diffusion
The storage conditions and the packaging should
be checked regularly. Any damages that occur
during the storage period should be repaired
immediately.
1
1
DANGER
WARNING
CAUTION
Storage and handling instructions for spare parts
NOTICE
NOTICE: Static electricity can damage printed
circuit boards.
Apply static-sensitive precautions when handling
these components.
Inspect the spare parts immediately after receipt
for damages. Report any damage to the shipping
company and the ABB service organization.
Observe the following to maintain spare parts in
good condition and to keep the warranty valid
during the warranty period:
• Keep spare parts in their original packaging
• Store printed circuit boards in antistatic bags
or boxes
• Storage temperature range: -5 °C to + 55 °C [23 °F
to 131 °F]
• Storage place requirements:
- Free of vibration and shock
- Protected against dust, sand, vermin and
insects
- Free of corrosive gases, salt or other impurities
that could damage electronic equipment.
- Dry; no condensation
- Relative air humidity: 5 to 85%
- If in doubt whether the maximum allowed
humidity may be exceeded, protect the spare
parts with an external heater
• Apply static-sensitive precautions when handling
printed circuit boards. Static electricity can
damage these components
- Do not touch a component without wearing a
wrist grounding strap
- Put the component on a grounded working
surface, protected against electrostatic
discharges
- Hold the component only at the edge
Disposal of packaging materials and components
Dispose of the packaging materials and the
components at the end of the lifetime of the drive
according to local regulations.