ABB ACS2000 User Manual page 54

54 A C S 2 0 0 0 , 4 K V U S E R M A N U A L
—
Have the following information at hand before
60
transporting the cabinet:
Transporting the
cabinet by crane using
• Appendix D - Mechanical drawings, located on the
lifting brackets
CD, provides details on specific dimensions and
(Frame 3 pictured)
weight of the cabinet
General notes on transportation
Observe the following points when transporting
the cabinet:
• The cabinet can be transported using a crane or a
forklift
• Drive components can be damaged during
transportation. Therefore, the cabinet must be
transported in an upright position
• Measure the drive and make sure that the
transportation path through any structures, such
as doorways, is sufficient for the size of the drive
• Ensure that no dirt enters the cabinet during
transportation. Keep the doors closed. Metallic
dust in particular may cause damage and lead to
malfunction when the drive is powered up
Using a crane
Observe the following points when using a crane:
• Use lifting equipment (web slings, chain slings,
round slings, safety hooks, shackles, etc.) that
corresponds to the size and weight of the cabinet
• Attach slings to the holes of the four lifting
brackets using a spreader bar (see Figure 60)
• Do not pass a sling through the fastening hole
• Use appropriate safety hooks or shackles to
attach a sling
• A spreader bar must be used when lifting the
drive. Verify that the straps are no more than 5°
from vertical (see Figure 60)
DANGER
WARNING: The drive should always be moved by
WARNING
level 2 certified rigger personnel.
CAUTION
NOTICE
Less
than 5 °
3
2
4
1
DANGER
1 Lifting brackets - each corner
2 Slings
WARNING
3 Spreader bar (not provided)
4 Lifting hooks
CAUTION
Maximum angle between lifting
NOTICE
slings must be less than 5° from
vertical.
• Lift the cabinet slowly and steadily to the
required clearance height, keeping the cabinet in
an upright position
• Check the horizontal position of the cabinet.
Reposition the slings if necessary
• Care must be taken to ensure that the lifting
straps do not damage the drive cabinet or fan
boxes
Note: The lifting brackets can be removed
after the cabinet has been installed at its
final location.
Using a forklift
Observe the following points when using a forklift:
• Transport the cabinet by fully inserting the forks
into the cabinet's forklift pockets either from the
right or left side of the cabinet (see Figure 61)
• Do not attempt to lift entire cabinet, a forklift is
only recommended when the opposite side is left
to slide on the floor