ABB ACS2000 User Manual page 86

86 A C S 2 0 0 0 , 4 K V U S E R M A N U A L
Identification mode
When the power supply is switched on, or the CDP
control panel is connected to the drive and the
auxiliary voltage has been switched on already, the
identification display appears showing the CDP
control panel version and then the ID-number of
the drive. When the CDP control panel is
initialized, the display changes as follows:
Display when initialized
After 2-3 seconds, information on drive (1, 2), the
application software in use (3), and the drive
identification (4) is displayed.
ACS2000 xxxx
< Device Name >
LDAI55xxC
ID-NUMBER 1
After another few seconds
1 L ->
StateINU
MOTOR SP
POWER
After another few seconds, the display changes to
the actual signal display mode. The status line of
the display alternates between DCGndNopen,
NotReadyOn.
1 L ->
StateINU
MOTOR SP
POWER
CDP312 PANEL V5.30
. . . . . . .
0.0 rpm
InitSeq...
0.00 rpm
0.0 kW
0.0 rpm
DCGndNopen
0.00 rpm
0.0 kW
Actual signal display mode
Overview
Two kinds of displays can be selected in the actual
signal display mode:
• Actual signal display
• Fault history display
The actual signal display appears first when the
actual signal display mode has been selected.
However, when the drive is in a fault condition,
the fault display will be shown instead.
The actual signal display is used to monitor the
drive without interfering in its operation. Three
selectable actual values are shown continuously
on the display.
The CDP control panel will automatically return to
the actual signal display mode from other modes
within one minute when no keys are pressed
(exceptions: status display and common
reference display when in drive selection
1
and fault display mode).
2
Actual values
• Group 01 - Measured or calculated motor values
3
• Group 02 - Measured or calculated drive values
• Group 03 - Reference values
4
• Group 04 - Status signals of IOEC I/O system
• Group 05 - Communication link and MV
switchgear status signals
• Group 06 - Software version, drive and motor
nominal values
• Group 07 - Control words
• Group 08 - Status words
• Group 09 - Fault and alarm words
DCGndNopen
NotReadyOn
See Appendix M - Signal and parameter
table, located on the CD, for the complete
list of selectable actual signals.