ABB ACS2000 User Manual page 43

c o n T r o l S y S T e m
—
Local control panel
46
The local control panel on the control compartment
Local operator panel
door serves as the basic user interface for
—
monitoring, control and operation of the
47
CDP control panel
drive and setting of parameters.
removal
1 CDP control panel
2 SUPPLY OFF/DISCHARGING
3 SUPPLY ON/CHARGING
4 FAULT/ALARM
5 GROUND SW RELEASED
6 Emergency OFF pushbutton
—
46
Features and functions of the CDP control panel
Features
The key features of the CDP control panel include:
• 4-line display
• User selectable display of actual values, e.g.
motor speed, current, voltage, torque, power
• Fault memory to support maintenance
1
2 3
5 4
6
Functions
The CDP control panel allows the operator to:
• Enter start-up data into the drive
• Control the drive by setting reference values and
by giving start, stop and direction commands
• Display three actual values at a time
• Display and set parameters
• Display information on the last 64 fault events
See chapter Local operation and chapter CDP
control panel for further information.
Panel removal
The CDP control panel can be removed from its
mounting cradle.
Before removing the CDP control panel during
operation of the drive, check the setting of
parameter 31.01 PANEL LOSS SUPERVISION. If the
parameter is set to NOT USED, the panel can be
removed without interrupting drive operation.
See Appendix M - Signal and parameter
table, located on the CD, for further
information on parameter settings.
Note: When the CDP control panel has been
removed during operation, the drive can
only be stopped by pressing the
emergency-off button.
When removing the panel, proceed as illustrated
below. After the panel has been removed, two LEDs
are visible:
• The green LED (see 4 in Figure 47) is illuminated
when the control voltage has been switched on
• The red LED is not used
1
1 CDP control panel
2 CDP removal
3 No CDP in place
4 Green LED
—
47
43
4
2 3