ABB ACS2000 User Manual page 110

110 A C S 2 0 0 0 , 4 K V U S E R M A N U A L
10. Frame 1 - Lift the phase module off the
module tray.
DANGER
Hold the phase module at the positions indicated
by the arrows.
WARNING
CAUTION: Due to weight of phase module, it is
CAUTION
recommended that two people are involved in
removal and in the case for Frame 2, the hoist is
NOTICE
used. Refer to section Dimensions and weight
for details on weights, replacement part
numbers and special tools.
10. Frames 2, 3 - Mount the lifting hoist to the drive
per hoist instructions. Hook up the lifting
harness at locations shown.
Using the hoist, lift the phase module off the
module tray.
11. Place the new module on the tray.
12. Gently push the phase module back into the
rack, ensuring cables are not pinched against
the cabinet, as far as it goes. Tighten the
fastening bolts that secure module to
cabinet on each side.
13. Reconnect fiber optic cables and control wires
to the phase module.
Be sure to connect the gray fiber optic connector to
the gray socket and the blue fiber optic connector
to the blue socket.
14. Remove the phase module tray tool.
15. Reinstall the plexiglass air plenum with the six
socket-head screws. If an AFE module was
replaced, be sure to reinstall air pressure
tube in plenum. Failure to do so will result
in pressure fault.
16. Switch on all miniature circuit breakers in the
control compartment.
17. Close the compartment door, follow lockout-
tagout removal procedures, unground, and
start the drive.
Replace 6 screws