ABB ACS2000 User Manual page 7

G e n e r a l i n f o r m aT i o n o n m a n U a l a n d e q U i p m e n T
User's responsibilities
It is the responsibility of those in charge of the
equipment to ensure that each person involved in
the installation, operation or maintenance of the
equipment has received the appropriate training
and has thoroughly read and clearly understands
the instructions in this manual and the relevant
safety instructions.
Intended equipment use
Those in charge of the equipment must ensure
that the equipment is used as specified in the
contractual documents, operated under
the conditions stipulated in the technical
specifications and on the rating plate of
the equipment, and serviced in the
intervals as specified by ABB.
Unauthorized modifications and constructional
changes of the equipment are not permitted.
Quality certificates and applicable standards
The following certificates and conformity
declarations are available with ABB:
• ISO 9001/ISO 14001 certificates stating
that ABB Inc. has implemented and maintains
a management system that fulfills the
requirements of the normative standards
• EC Conformity Declaration
• Standards and certifications
EN, IEC, CE and cUL.
Meets IEEE 519 and IEC 61000-2-4
Trademarks
Names that are believed to be trademarks of other
companies and organizations are designated
as such. The absence or presence of such a
designation should, however, not be regarded
as an offense to the legal status of any trademark.
The following registrations and trademarks are
used in this manual:
Registered trademark of Microsoft
Windows® Corporation
Industrial IT™ Trademark of ABB
DriveWare® Registered trademark of ABB
DriveMonitor™ Trademark of ABB
Registered trademark of Xerox
Ethernet® Corporation
Registered trademark of Profibus
Profibus® International (P.I.)
Registered trademark of ControlNet
ControlNet® International, Ltd.
Registered trademark of the Modbus IDA
Modbus® organization
Registered trademark of the Open
DeviceNet® DeviceNet Vendor Association, Inc.
Registered trademark of the Kirk Key
Kirk® key Interlock Company
Registered trademark of HMS Industrial
Anybus® Networks, Inc.
3M Scotch-Brite™ Registered trademark of 3M
Writing conventions
The following icons and text conventions are used
in the manual.
Illustrates an illuminated pilot light
or pushbutton
Illustrates a button or key to be
pressed
Arrows indicate an alternating
display message
Refers to further information
in a separate document
Used to list items or steps in a
procedure, where the sequence
• Bulleted list
does not matter
- Bulleted list of a
subsection Used to list items or for
following a main procedures, where the sequence
paragraph does not matter
Steps of a procedure to be
1. followed in the specified order
Figure legend, numbers identify
— the items referred to in the
01 illustration above
Used to highlight switches to be
operated, status messages shown
Bold in a display and special terms
UPPERCASE Refer to a parameter
Used for references to illustrations,
chapters and supplementary
Italic documentation
7