Instrument Specifications - tecan HYDROFLEX PLUS Instructions For Use Manual

2. General
2.3

Instrument Specifications

PARAMETERS
General
Display unit
Keyboard
Number of dispensing
channels
Manifold types
USB Interface
Variable
Volume of solution
dispensed
Dispensing accuracy
18
UNAUTHORIZED MODIFICATION OF THE HYDROFLEX PLUS, ANY OF
ITS OPTIONS AND/OR COMPONENTS AS WELL AS ON ANY
CORRESPONDING SOFTWARE OR SPARE PARTS WILL RESULT IN A
LOSS OF WARRANTY AND A POTENTIAL LOSS IN INSTRUMENT
IT IS IMPORTANT TO UNDERSTAND THAT THE PROPER INSTALLATION
OF THE INSTRUMENT AND HYDROCONTROL SOFTWARE ALONE WILL
NOT ENSURE COMPLIANCE WITH NATIONAL, REGIONAL OR LOCAL
REGULATIONS. A RANGE OF POLICIES AND STANDARD OPERATING
PROCEDURES ACCORDING TO APPLICABLE REGULATIONS MUST
ADDITIONALLY BE ESTABLISHED.
Instrument specifications have been defined using Greiner flat-bottom
compact 96-well microplates and may vary using other 96-well plates or
The table below lists the specifications for the instrument. All specifications listed
below are based on the following instrument settings:
Dispense/Wash rate:
Aspiration rate:
CHARACTERISTICS
Liquid Crystal Display with two rows of sixteen digits
Four key membrane keyboard
Up to four channels
8 and 16-way manifold
All connected devices must be approved and listed as per IEC 60950-1
Information Technology Equipment – Safety or equivalent local standards.
50 - 3000 µl in 50 µl increments for washing
50 - 400 µl in 50 µl increments for dispensing
<= 2 %
Measured under following conditions:
8-way manifold, 300 µl, dispensing rate 3 (250 µl/s/well), wash buffer, Greiner
96 well flat bottom plate
HYDROFLEX PLUS No. 30199906 Rev. No. 1.1
CAUTION
PERFORMANCE.
CAUTION
Note
96-well strip-plates.
250 µl/s
3
2022-01