Define/Edit A Program (Define/Edit Menu) - tecan HYDROFLEX PLUS Instructions For Use Manual

5.2.2

Define/Edit a Program (Define/Edit Menu)

DEFINE EDIT
< >
PROG1:
- +
NAME:EXAMPLE
567890, ,
PLATE MODE
- +
Plate 1, GRE96ft
- +
NO. OF CYCLES 1
- +
C1 P1 ASP
- +
C1 P2 ASP
- +
C2 CYCLE
- +
PROGRAM END?
- +
FINAL ASP?
START
< >
2022-01
Press OK to define or edit a program on the instrument.
EXIT OK
Press - or + to select a program position in which a new
program will be defined or select an already existing
EXIT OK
program to edit.
Enter the required name for the program (up to eight
characters). Select a character by moving it with the cursor
keys between the commas and pressing the return key
ABCDE
Select
return key
mode selection.
Press - or + to select between plate or strip mode.
EXIT OK
Press - or + to select other plate types.
EXIT OK
Press - or + to select the number of cycles
(cycles can be repeated up to 9 times).
EXIT OK
Press - or + to select the process step (ASP, DISP, WASH,
SOAK, USER PR.). Press OK to define the selected
process step. Once the process step has been defined the
display appears with the step position incremented (e.g. P1
EXIT OK
becomes P2).
Select - or + to define the next process step.
Press OK to define the selected process step.
EXIT OK
To add another cycle, press + until CX CYCLE is displayed
(X is the number of the next cycle). Press OK to define the
EXIT OK
number of cycles.
Press – or + and press OK to select PROGRAM END
to finish defining the program.
EXIT OK
Add a final aspiration step if necessary.
The parameters for the final aspirate step can be selected.
NO YES
Once the program has been defined,
the Start menu appears again.
EXIT OK
HYDROFLEX PLUS No. 30199906 Rev. No. 1.1
, to delete a character. Select
to save the program name and continue to
5. Programming Procedure
and press the
41