Keysight M8121A User Manual page 124

6 Remote Programming
Parameter Suffix
Parameter Suffix
124
• INTX24 – interpolation x24 mode
• INTX48 – interpolation x48 mode
None
Description Use this command or query to set or get the waveform output mode. If the
DAC resolution is changed in direct mode or if there is a switch from direct
mode to interpolated mode or vice versa, all waveform segments for this
channel are invalidated.
The interpolated modes INTX3, INTX12, INTX24 and INTX48 are only
available when the DUC option is installed.
Note that although this command is channelized, the output mode must
remain the same for both channels. Changing one channel will change the
other to be the same.
Examples Command
:TRAC:DWID INTX3
Query
:TRAC:DWID?
:TRACe[1|2]:DELete
Command
:TRACe[1|2]:DELete <segment_id>
Query
Parameters
<segment_id>
None
Description <segment_id> – id of the segment, must be 1.
Delete a segment. The command can only be used in program mode.
Examples Command
:TRAC:DEL 5
:TRACe[1|2]:DELete:ALL
Command
:TRACe[1|2]:DELete:ALL
Query
Parameters None
Keysight M8121A Arbitrary Waveform Generator User Guide