Initiate Commands - Keysight M8121A User Manual

:INITiate Commands

Parameter Suffix
Parameter Suffix
Keysight M8121A Arbitrary Waveform Generator User Guide
:INITiate:IMMediate[1|2]
Command
:INITiate:IMMediate[1|2]
Parameters None
None
Description This command starts signal generation on a channel or arms the channel
in triggered mode. If channels are coupled, the signal generation on both
the channels will start.
Examples Command
:INIT:IMM1
:INITiate:CONTinous[1|2][:STATe][?] OFF|ON|0|1
Command
:INIT:CONT[1|2]:STAT[?]
Long :INITiate:CONTinuous[1|2]:STATe[?]
Parameters ON: Continuous
OFF: Triggered
None
Description This command is used to set or query the continuous mode, or to set the
triggered mode.
0/OFF – Continuous mode is off.
1/ON – Continuous mode is on. Trigger mode is "automatic".
Examples Command
:INIT:CONT:STAT ON
Query
:INIT:CONT:STAT?
Remote Programming
91
6