Paging Amplifier Web; Log In To The Configuration Home Page - CyberData 011085 Operation Manual

2.3.1 Paging Amplifier Web Page Navigation
Table 2-9

2.3.2 Log in to the Configuration Home Page

1. Open your browser to the Paging Amplifier IP address.
Note
Note
Note
The Paging Amplifier ships in DHCP mode. To get to the Home page, use the discovery utility to
scan for the device on the network and open your browser from there.
2. When prompted, use the following default Web Access Username and Web Access
Operations Guide
shows the navigation buttons that you will see on every Paging Amplifier web page.
Table 2-9. V2 Paging Amplifier Web Page Navigation
Web Page Item
If the network does not have access to a DHCP server, the device will default to an IP
address of 10.10.10.10.
Make sure that the PC is on the same IP network as the Paging Amplifier.
You may also download CyberData's VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products. 

CyberData's VoIP Discovery Utility program is available on the VoIP V2 Paging Amplifier
product page at:
http://www.cyberdata.net/support/voip/discovery_utility.html
Password to access the Home Page
Web Access Username: admin
Web Access Password: admin
Link to the Home page.
Link to the Update Firmware page.
(Figure 2-16):
930363H
Installing the VoIP V2 Paging Amplifier
Configure the Paging Amplifier Parameters
Description
CyberData Corporation
18