Configure The Paging Amplifier Parameters - CyberData 011085 Operation Manual

2.3 Configure the Paging Amplifier Parameters

●
●
●
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway
Note
Operations Guide
To configure the Paging Amplifier online, use a standard web browser.
Configure each Paging Amplifier and verify its operation before you mount it. When you are
ready to mount a Paging Amplifier enclosure, refer to
for instructions.
All Paging Amplifier are initially configured with the default IP settings indicated 
in Table 2-8.
Parameter
a
a
a
a. Default if there is not a DHCP server present.
When configuring more than one Paging Amplifier, attach the Paging Amplifiers to the
network one at a time to avoid IP address conflicts.
Table 2-8. Factory Default Settings
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
930363H
Installing the VoIP V2 Paging Amplifier
Configure the Paging Amplifier Parameters
Appendix A, "Mounting the Amplifier"
Factory Default Setting
CyberData Corporation
17
