Table of Contents
Advertisement
Maintenance
11. Select Tape to print the first vertical test pattern.
a. Select the Pattern number: field.
b. Type in the number of the best aligned pattern.
c. Select OK.
d. Select Next to continue.
12. Repeat step 11 to print the second vertical test pattern.
13. If the alignment was successful, a message appears indicating that the print heads have been
vertically aligned to print on tape. Select Next to continue to the horizontal alignment.
14. Select Tape to print the first horizontal test pattern.
a. Select the Pattern number: field.
b. Type in the number of the best aligned pattern.
c. Select OK.
d. Select Next to continue.
15. Repeat step 14 to print the second horizontal test pattern.
16. If the alignment was successful, a message appears indicating that the print heads have been
aligned to print on envelopes and tape. Select Done.
Envelope alignment only
1. Type in the length of your envelope.
a. Use the + and - buttons to adjust the length measurement. The minimum and maximum
lengths allowed are displayed on the screen.
b. Select Next to continue.
2. Select the location on the envelope where most full color graphics are printed.
Do not change this setting unless instructed to do so.
Select Left if most full color graphics are printed as part of the return address.
l
Select Center (recommended) if most full color graphics are printed as part of a graphic
l
or text message.
Select Right if most full color graphics are printed as part of a permit.
l
Select Next to continue.
3. Place an envelope on the feed deck and select Start to print the vertical test pattern.
Pitney Bowes
Operator Guide
April 2022
214
Advertisement
Table of Contents
