Communication Interfaces: Setting And Function; Menu Overview Of "External Interfaces; Ssm/Sbm Relay Application And Function - Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual

en
12 Communication interfaces:
Setting and function
12.1 Menu overview of "External inter-
faces"
12.2 SSM/SBM relay application and
function
64

Communication interfaces: Setting and function

Name
Parallel operation: OFF
Parallel operation: Parallel opera-
tion
Parallel operation: This pump
head active
Parallel operation: Pump partner
active
Table 21: Active influences
Select the following in the "Settings" menu
Universal Display text
1.0 Settings
1.3 External interfaces
Possible selection of external interfaces:
Universal Display text
1.3.1 Relay output (SSM/SBM)
1.3.2 Control input
1.3.3 Analogue input (AI1)
1.3.4 Analogue input (AI2)
1.3.5 Wilo Net setting
NOTICE
The submenus for setting the analogue inputs are only available depending on the
selected control mode.
Universal Display text
1.0 Settings
1.3 External interfaces
1.3.1 Relay output (SSM/SBM)
1.3.2 Control input
1.3.3 Analogue input (AI1)
1.3.4 Analogue input (AI2)
1.3.5 Wilo Net setting
The SSM/SBM relay can be configured in the "Relay function" submenu either as a col-
lective fault signal SSM or as a collective run signal SBM.
The following table gives an overview of the possible settings:
Displayed Description
symbols
Twin-head pump is set in parallel op-
eration.
Both pumps are inactive in control
mode.
Twin-head pump is set in parallel op-
eration.
Both pumps are active in parallel in
control mode.
Twin-head pump is set in parallel op-
eration.
This pump head is active in control
mode. The pump partner is inactive.
Twin-head pump is set in parallel op-
eration.
The pump partner is active in control
mode.
This pump head is inactive.
In the event of an error at the pump
partner, this pump head will run.
:
WILO SE 2022-05