Control Settings - Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual

en
9.4.6 Submenu
9.4.7 Main menu "Settings" - Menu
overview
48
Commissioning
Name
Fault
Pump kick
EXT.OFF
Pump operation OFF
Setpoint OFF
Substitute speed
Fallback Off
No active influences
Table 18: Active influences
Active influences on the hydraulic output - displayed in the home screen
Name
Limitation of the hydraulic out-
put
No active influences
Table 19: Active influences
Each submenu is made up of a list of submenu items.
The title identifies a subsequent submenu or settings dialogue.
The following table gives an overview of the "Settings" main menu:
Universal Display text
1.0 Settings
1.1

Control settings

1.1.1 Control mode
Δp-v ∆p-v
Δp-c ∆p-c
n-c n-c
PID control PID controller
1
1.1.2 Setpoint
1.1.2 Δp-v, Δp-v
1.1.2 Δp-c, Δp-c
1.1.2 n-c, n-c
1.1.2 PID PID control
1.1.2 Δp-v Setpoint ∆p-v
H set = H target =
1.1.2 Δp-c Setpoint Δp-c
H set = H target =
1.1.2 n-c Setpoint n-c
n act = n is =
1.1.2 PID Setpoint PID
Displayed Description
symbols
Error active, motor stops
Pump kick active
Digital input DI EXT. OFF active
Pump manually switched off
Analogue signal OFF
Pump is running at substitute
speed
Replacement mode active, but
set to motor stop
No active influences active
Dis- Description
played
sym-
bols
Limitation of hydraulic output due to ex-
ternal influences such as too high tem-
perature or insufficient power supply.
- No active influences on the volume flow.
1
WILO SE 2022-05