Electrical Work; Transport - Wilo Yonos GIGA2.0-I Installation And Operating Instructions Manual

2.3

Electrical work

2.4

Transport

Installation and operating instructions Wilo-Yonos GIGA2.0-I/-D
Safety
ƒ
Have electrical work carried out by a qualified electrician.
ƒ
When connecting to the local power supply system, comply with the nationally ap-
plicable guidelines, standards and regulations as well as specifications issued by
the local energy supply companies.
ƒ
Before commencing work, disconnect the product from the mains and secure it
against being switched on again.
ƒ
Give personnel training on how to establish the electrical connection and the
methods for switching off the product.
ƒ
Protect the electrical connection with a residual-current device (RCD).
ƒ
Observe the technical information in these installation and operating instructions
as well as on the rating plate.
ƒ
Earth the product.
ƒ
Comply with the manufacturer's specifications when connecting the product to
electrical switching systems.
ƒ
Have a defective connection cable replaced immediately by a qualified electrician.
ƒ
Never remove operating elements.
ƒ
If radio waves (Bluetooth) lead to hazards (e.g. in hospitals), they must be switched
off or removed if they are not desired or prohibited at the installation location.
DANGER
When dismantled, the permanent magnet rotor inside the pump can pose mortal
danger for people with medical implants (e.g. pacemakers).
• Follow the general behavioural guidelines that apply to handling electrical
devices!
• Do not open the motor!
• Dismantling and installation of the rotor may only be carried out by Wilo cus-
tomer service! If you have been fitted with a pacemaker, you must not carry out
this kind of work!
NOTICE
The magnets inside the motor do not pose a danger provided the motor is com-
pletely assembled. Persons with pacemakers can approach the pump without re-
strictions.
ƒ
Wear protective equipment:
–
safety gloves for protection against cuts
–
safety shoes
–
sealed safety goggles
–
safety helmet (when using lifting equipment)
ƒ
Only use legally specified and approved lifting gear.
ƒ
Select the lifting gear based on the prevailing conditions (weather, attachment
point, load etc.).
ƒ
Always attach the lifting gear to the designated attachment points (lifting eyes).
ƒ
Position the lifting equipment in a way that ensures stability during use.
ƒ
When using lifting equipment, a second person must be present to coordinate the
procedure if required (e.g. if the operator's field of vision is blocked).
ƒ
Persons must not stand underneath suspended loads. Do not move loads over
workplaces where people are present.
en
9