Table of Contents
Advertisement
26 Introduction to the manual
Use of component designations
Some device names in the manual include the item designation in brackets, for example
[Q20], to make it possible to identify the components in the circuit diagrams of the drive.
Quick installation, commissioning and operation flowchart
Task
Plan the electrical installation and acquire the accessories needed
(cables, fuses, etc.).
Check the ratings, required cooling air flow, input power connec-
tion, compatibility of the motor, motor connection, and other
technical data.
Check the installation site.
Unpack and check the drive (only intact units may be started up).
Make sure that all necessary optional modules and equipment
are present and correct.
Install the drive mechanically.
Route the cables.
Connect the power cables.
Connect the control cables.
Check the installation.
Start the drive up.
Operate the drive: start, stop, speed control etc.
See
Guidelines for planning the electrical install-
ation (page 73)
Technical data (page 175)
Ambient conditions (page 188)
Mechanical installation (page 51)
Routing the cables (page 84)
Electrical installation (page 93)
Installation checklist (page 135)
If the drive has been non-operational for
more than one year, reform the DC link ca-
pacitors. See
Converter module capacitor
reforming instructions (3BFE64059629
[English]).
Start-up (page 137)
ACS880 quick start-up guide, firmware
manual
Advertisement
Table of Contents
