Connecting a PC
WARNING!
Do not connect the PC directly to the control panel connector of the control unit as
this can cause damage.
A PC (with, for example, the Drive composer PC tool) can be connected as follows:
1.
Connect a ACS-AP-... or ACH-AP-... control panel to the unit either
•
by inserting the control panel into the panel holder or platform, or
•
by using an Ethernet (eg, Cat 5e) networking cable.
2.
Remove the USB connector cover on the front of the control panel.
3.
Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4.
The panel will display an indication whenever the connection is active.
5.
See the documentation of the PC tool for setup instructions.
?
Stop
Loc/Rem
Start
2
Panel bus (Control of several units from one control panel)
One control panel (or PC) can be used to control several drives (or inverter units, supply
units etc.) by constructing a panel bus. This is done by daisy-chaining the panel connections
of the drives. Some drives have the necessary (twin) panel connectors in the control panel
holder; those that do not require the installation of an FDPI-02 module (available separately).
For further information, see the hardware description and
interface user's manual (3AUA0000113618
The maximum allowed length of the cable chain is 100 m (328 ft).
1.
Connect the panel to one drive using an Ethernet (for example Cat 5e) cable.
•
Use Menu - Settings - Edit texts - Drive to give a descriptive name to the drive
•
Use parameter 49.01* to assign the drive with a unique node ID number
•
Set other parameters in group 49* if necessary
•
Use parameter 49.06* to validate any changes.
*The parameter group is 149 with supply (line-side), brake or DC/DC converter units.
Repeat the above for each drive.
2.
With the panel connected to one unit, link the units using Ethernet cables.
2
3b
3a
[English]).
Electrical installation 111
4
USB connected
?
Stop
Start
Loc/Rem
FDPI-02 diagnostics and panel
11