Table of Contents
Advertisement
62 Mechanical installation
Attaching the cabinet (marine units)
￭
See the dimension drawing delivered with the drive for details of the fastening points.
Fasten the cabinet to the floor and roof (wall) as follows:
1.
Bolt the unit to the floor through the flat bars at the base of the cabinet using M10 or
M12 screws.
2.
If there is not enough room behind the cabinet for installation, clamp (a) the rear edges
of the flat bars (c) to the floor. See the figure below.
3.
Attach corner brackets (d) to the lifting eye holes. Fasten the corner brackets to the
rear wall and/or roof with suitable hardware such as U-brackets (e).
2
a
a
Clamp (not included)
b
Back panel of cabinet
c
Flat bars at base of cabinet
b
c
d
Corner bracket (included)
e
U-bracket (not included)
-
-
3
d
e
M16
Advertisement
Table of Contents
