Table of Contents
Advertisement
Joining cabinet sections together
Wide cabinet line-ups are delivered in multiple sections. The sections are to be joined on-site
using a joining cubicle at the end of one section (a common motor terminal cubicle can also
act as a joining cubicle). The screws required for the joining are enclosed in a plastic bag
inside the cabinet.
1.
Fasten the first section to the floor.
2.
Remove any plates covering the rear post of the joining cubicle.
3.
Slide Axilock connectors onto the coolant pipes at the joint.
4.
Align the two sections.
The coolant pipe ends must be aligned as shown.
5...15 mm (0.2...0.6")
< 2°
< 3 mm (0.12")
Mechanical installation 63
10
Advertisement
Table of Contents
