Use Of Component Designations; Quick Installation, Commissioning And Operation Flowchart - ABB ACS880-07 Hardware Manual

28 Introduction to the manual

Use of component designations

Some device names in the manual include the component designation in brackets (for
example, [Q20]). This will help you to identify the components in the circuit diagrams
of the drive.

Quick installation, commissioning and operation flowchart

Task
Plan the electrical installation and acquire the accessories
needed (cables, fuses, etc.).
Check the ratings, required cooling air flow, input power
connection, compatibility of the motor, motor connection,
and other technical data.
Check the installation site.
Unpack and check the drive (only intact units may be started
up).
Make sure that all necessary optional modules and equipment
are present and correct.
Install the drive mechanically.
Route the cables.
If the drive is about to be connected to an IT (ungrounded)
system, check that the drive is not equipped with EMC filter
+E202.
Connect the power cables.
Connect the control cables.
Check the installation.
Start the drive up.
Operate the drive: start, stop, speed control etc.
See
Guidelines for planning the electrical in-
stallation (page 89)
Technical data (page 223)
Ambient conditions (page 239)
Mechanical installation (page 67)
Routing the cables (page 105)
Compatibility check - IT (ungrounded)
earthing system (page 116)
Electrical installation (page 115)
Installation checklist (page 171)
If the drive has been non-operational for
more than one year, reform the DC link
capacitors. See Converter module capa-
citor reforming instructions
(3BFE64059629 [English]).
Start-up (page 173)
ACS880 quick start-up guide, firmware
manual