Table of Contents
Advertisement
Mechanical installation
Contents of this chapter
This chapter describes the mechanical installation procedure of the drive.
Examining the installation site
Examine the installation site. Make sure that:
•
The installation site is sufficiently ventilated or cooled to remove heat from the drive.
See the technical data.
•
The ambient conditions of the drive meet the specifications. See the technical data.
•
There is sufficient free space above the drive for cooling, maintenance, and operation
of the pressure relief (if present).
•
The floor that the drive cabinet is installed on is of non-flammable material, as smooth
as possible, and strong enough to support the weight of the unit. Check the floor flatness
with a spirit level. The maximum allowed deviation from the surface level is 5 mm (0.2 in)
in every 3 meters (10 ft). Level the installation site, if necessary, as the cabinet is not
equipped with adjustable feet.
Necessary tools
The tools required for moving the unit to its final position, fastening it to the floor and wall
and tightening the connections are listed below:
•
crane, fork-lift or pallet truck (check load capacity!), slate/spud bar, jack and rollers
•
Pozidriv and Torx screwdrivers
•
torque wrench
•
set of wrenches or sockets.
Mechanical installation 51
4
10
Advertisement
Table of Contents
