Table of Contents
Advertisement
Connecting a PC to the FDPI-02
You can connect a PC to the FDPI-02 unit either through a control panel or to a
commercial USB - RS-485 converter or Ethernet - RS-485 converter.
Note:
•
Never connect the PC to connector X2 of FDPI-02. The panel voltage or LED signals
may cause damage to the PC.
•
Simultaneous control panel and PC communication is not allowed.
•
The FDPI-02 cannot be used for connection to an Ethernet network.
Connecting a PC through a control panel
￭
For connecting a PC to a control panel (connected to the FDPI-02):
1.
Lift the USB connector cover on the control panel from bottom upwards.
2.
Insert the USB cable Mini-B plug in the control panel USB connector (a).
3.
Insert the USB cable A-plug in the USB connector of the PC. The panel displays:
USB connected (b).
For more information on connecting a PC tool to a drive through the control panel,
see
ACS-AP-... Assistant control panels user's manual [3AUA0000085685
Electrical installation 23
(English)].
Advertisement
Table of Contents
