70 Electrical installation
6.
Connect the conductors to appropriate terminals.
7.
Refit any shrouds removed earlier.
Connecting a PC
WARNING!
Do not connect the PC directly to the control panel connector of the control
unit as this can cause damage.
A PC (with, for example, the Drive composer PC tool) can be connected as follows:
1.
Connect a ACS-AP-... or ACH-AP-... control panel to the unit either
•
by inserting the control panel into the panel holder or platform, or
•
by using an Ethernet (eg, Cat 5e) networking cable.
2.
Remove the USB connector cover on the front of the control panel.
3.
Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4.
The panel will display an indication whenever the connection is active.
5.
See the documentation of the PC tool for setup instructions.
?
Stop
Loc/Rem
Start
2
2
3b
3a
4
USB connected
?
Stop
Start
Loc/Rem